Doug Kerr
Well-known member
In fairly modern photographic exposure meters having a mechanical, dial-form "slide rule" for calculating exposure settings, the calculator is typically organized so that this is the most convenient scenario of use:
The user sets the sensitivity (speed) of the film or digital camera, and enters the luminance or illuminance indication from the meter movement. The calculator then presents a continuum of combinations of f-number and shutter speeds, any of which will give the photographic exposure the meter recommends.
Elsewhere in this forum there have been extensive discussions of the Hurter & Driffield Actinograph exposure calculator, an instrument dating to the 1800s. It is a "linear-form" slide rule.
It is interesting to note that this is organized so that the most convenient scenario of use is this:
The user sets the film ("plate") speed and the exposure time. The calculator then presents a continuum of combinations of illuminance (not measured, but from a chart based on date and time, for a certain latitude) and aperture.
It would not at all be convenient, having decided what illuminance was likely present at this date and time, and knowing the sensitivity ("speed") of the film, to then see combinations of aperture and shutter speed that would fulfill the instrument's "recommendation" as to photographic exposure.
We thus see here an impact of differing photographic practices over the years on the organization of exposure calculators.
Best regards,
Doug
The user sets the sensitivity (speed) of the film or digital camera, and enters the luminance or illuminance indication from the meter movement. The calculator then presents a continuum of combinations of f-number and shutter speeds, any of which will give the photographic exposure the meter recommends.
Elsewhere in this forum there have been extensive discussions of the Hurter & Driffield Actinograph exposure calculator, an instrument dating to the 1800s. It is a "linear-form" slide rule.
It is interesting to note that this is organized so that the most convenient scenario of use is this:
The user sets the film ("plate") speed and the exposure time. The calculator then presents a continuum of combinations of illuminance (not measured, but from a chart based on date and time, for a certain latitude) and aperture.
It would not at all be convenient, having decided what illuminance was likely present at this date and time, and knowing the sensitivity ("speed") of the film, to then see combinations of aperture and shutter speed that would fulfill the instrument's "recommendation" as to photographic exposure.
We thus see here an impact of differing photographic practices over the years on the organization of exposure calculators.
Best regards,
Doug
Last edited: